Ryobi HT230 manual Using the Mandrels, See Figures 6

Page 13

OPERATION

CAUTION:

To prevent damage to the spindle or spindle lock, always allow motor to come to a complete stop before engaging the spindle lock.

USING THE MANDRELS

See Figures 6 - 8.

Three types of mandrels have been included for use with this kit. The standard mandrel is used with the cut-off discs, grinding wheels, emery wheel, and cut-off wheels. The screw mandrel is used with the polishing wheels and polishing drum. The drum mandrel is used with the sanding drums.

To install:

Unplug the rotary tool.

Install the mandrel.

If using the standard mandrel:

Press and hold the spindle lock.

Insert the slot end of the provided wrench into the slot on top of the mandrel and unscrew.

Remove mandrel screw and washer.

Place desired accessory over mandrel shaft and align accessory hole with mandrel hole.

Insert mandrel screw with washer through the accessory and mandrel shaft holes.

NOTE: The mandrel washer should be placed between the mandrel screw and the accessory.

Tighten using provided wrench.

If using the screw mandrel:

Align desired accessory hole with mandrel screw head.

Screw accessory onto mandrel by twisting clockwise until secure.

If using the drum mandrel:

Align appropriate sized sanding drum over mandrel and push down to completely cover drum end of mandrel.

NOTE: If necessary, tighten the screw on the drum mandrel head to expand the drum and securely hold the sanding drum in place.

MANDREL SCREW WASHER

CUT-OFF DISC

MANDREL

COLLAR

COLLET

Fig. 6

TIGHTEN

SPINDLE LOCK

 

Fig. 7

13

Image 13
Contents Save this Manual for Future Reference OPERATOR’S ManualIntroduction WarrantyElectrical Safety General Safety RulesPersonal Safety Work AreaService Specific Safety RulesName DESIGNATION/EXPLANATION SymbolsSymbol Signal Meaning Electrical Cord Length Wire Size A.W.GDouble Insulation Electrical ConnectionProduct Specifications FeaturesOn I /OFF O Assembly Applications OperationTurning the Rotary Tool ON/OFF Changing ColletsQuantity Accessory Application Accessory ChartRemoving Accessories Installing AccessoriesSee Figures 4 See Figures 6 Using the MandrelsSelecting the Right Speed Balancing AccessoriesSlower Speeds Engraving DiscsCutter RubberLearning to use the rotary tool Operating the Rotary ToolTo operate the rotary tool Operating the Flex Shaft Telescoping Tool Hanger with Clamp on BaseSee Figures 12 To remove accessories from the flex shaft To install accessories into the flex shaftTo operate the rotary tool using the flex shaft To assemble the plunge cutting accessory Using the Plunge Cutting AccessoryTo install the plunge cutting accessory on the rotary tool To use the plunge cutting accessoryGeneral Maintenance MaintenanceLubrication Page Service Model NO. and Serial no