Ryobi HT230 manual Using the Plunge Cutting Accessory, See Figures 15

Page 19

OPERATION

USING THE PLUNGE CUTTING ACCESSORY

See Figures 15 - 16.

The plunge cutting accessory attaches to the end of the rotary tool. Depth of cut can be adjusted in 1/8 in. increments up to 1 in.

To assemble the plunge cutting accessory:

Hold the cup-shaped accessory piece with the cup side facing down.

Insert the cylinder-shaped accessory piece up through the cup-shaped piece. The legs of the cylinder-shaped piece should be facing down.

Align the groove in the cylinder-shaped piece with the screw in the cup-shaped piece.

Tighten the screw to secure the cylinder-shaped piece in place.

To install the plunge cutting accessory on the rotary tool:

Unplug the rotary tool.

Install desired drill bit into rotary tool.

Loosen collet sleeve by turning counterclockwise and remove.

Insert rotary tool into cylinder-shaped piece of the accessory.

Turn accessory clockwise until it is securely screwed onto the rotary tool.

To use the plunge cutting accessory:

Loosen the plunge cutting accessory screw until the cup-shaped piece can be easily moved.

Align cup-shaped piece with the desired measurement depth on the accessory scale.

Tighten screw until the accessory is secured.

Connect rotary tool to power supply.

Hold the tool in front and away from you, keeping the tool bit clear of the workpiece.

Turn on the tool and let the motor and bit build up to full speed.

Lower the tool gradually until the bit contacts the workpiece.

Move the tool continuously at a steady, consistent pace.

NOTE: The bit has reached the desired depth when the plunge cutting accessory makes contact with the workpiece.

Use just enough pressure to keep the tool from chattering or bouncing.

NOTE: Heavy pressure will decrease the tool’s speed and put a strain on the motor. Normally the weight of the tool alone is adequate for most jobs.

Lift the tool away from the workpiece before turning off the tool.

COLLET

SLEEVE

GROOVE

 

CYLINDER

SCREW

PIECE

 

CUP

PIECE

Fig. 15

SCALE

SCREW

Fig. 16

19

Image 19
Contents Save this Manual for Future Reference OPERATOR’S ManualIntroduction WarrantyWork Area General Safety RulesElectrical Safety Personal SafetyService Specific Safety RulesName DESIGNATION/EXPLANATION SymbolsSymbol Signal Meaning Electrical Connection Cord Length Wire Size A.W.GElectrical Double InsulationProduct Specifications FeaturesOn I /OFF O Assembly Changing Collets OperationApplications Turning the Rotary Tool ON/OFFQuantity Accessory Application Accessory ChartRemoving Accessories Installing AccessoriesSee Figures 4 See Figures 6 Using the MandrelsSelecting the Right Speed Balancing AccessoriesSlower Speeds Rubber DiscsEngraving CutterLearning to use the rotary tool Operating the Rotary ToolTo operate the rotary tool Operating the Flex Shaft Telescoping Tool Hanger with Clamp on BaseSee Figures 12 To remove accessories from the flex shaft To install accessories into the flex shaftTo operate the rotary tool using the flex shaft To use the plunge cutting accessory Using the Plunge Cutting AccessoryTo assemble the plunge cutting accessory To install the plunge cutting accessory on the rotary toolGeneral Maintenance MaintenanceLubrication Page Service Model NO. and Serial no