OPERATION
WARNING!
To reduce the risk of injury, wear safety goggles or glasses with side shields. Unplug the tool before changing accessories or making adjustments.
Selecting Action (Fig. 4)
The MILWAUKEE
Fig. 4
Selector lever
1.For drilling, turn the selector lever to the drill symbol 
.
2.For drilling with hammer action , turn the selector lever
to the 
.
NOTE: To engage the hammering mechanism, maintain pressure on the bit. When pressure on the bit is released, the hammering action will stop.
Using Forward/Reverse Lever (Fig. 5)
The forward/reverse lever can only be adjusted when the trigger is not pressed. Always allow the motor to come to a complete stop before using the forward/reverse lever.
Fig. 5
Forward | Reverse |
1.For forward (clockwise) rotation, push the forward/reverse lever
to the symbol 
.
2.For reverse (counterclockwise) rotation, push the forward/reverse
lever to the symbol
.
NOTE: When drilling with hammer action, use the tool in forward rotation (clockwise) only.
Starting, Stopping & Controlling Speed
1.To start the tool, pull trigger.
2.To stop the tool, release trigger.
3.To vary the speed, increase or decrease pressure to trigger. The further the trigger is pulled, the greater the speed.
Operating
Position the tool, grasp the handles firmly and pull the trigger. Always hold the tool securely using both handles and maintain control. This tool has been designed to achieve top performance with only moderate pressure. Let the tool do the work.
If the speed begins to drop off when drilling deep holes, pull the bit partially out of the hole while the tool is running to help clear dust. Do not use water to settle the dust since it will clog the bit flutes and tend to make the bit bind in the hole.
APPLICATIONS
WARNING!
To reduce the risk of electric shock, check work area for hidden pipes and wires before drilling.
Drilling in Wood, Composition Materials and Plastic
When drilling in wood, composition materials and plastic, select the drill operating mode. Start the drill slowly, gradually increasing speed as you drill. When drilling into wood, use wood augers or twist drill bits. Always use sharp bits. Select low speeds for plastics with a low melting point.
Drilling in Metal
When drilling in metal, select the drill operating mode. Use high speed steel twist drills or hole saws. Use a center punch to start the hole. Lubricate drill bits with cutting oil when drilling in iron or steel. Use a coolant when drilling in nonferrous metals such as copper, brass or aluminum. Back the material to prevent binding and distortion on breakthrough.
Drilling in Masonry
When drilling in masonry, select the drill with hammer action operating mode. Use high speed
page 6