P 5/22
Repair
[3] DISASSEMBLY/ASSEMBLY
[3]
Holder section for Drill chuck of BHR262T, HR262TD
DISASSEMBLING for BHR262, HR262D
Fig. 4
Remove Cap 35 with slotted screw- driver, then remove Ring spring 19 using 1R003 with 1R212.
Separate Chuck cover. Then remove Steel ball 7.0 while pressing down Ring 21.
Bit holder section can be disassembled as drawn above.
1R003 |
| |
1R212 | Cap 35 | |
| ||
Ring 21 | Ring spring 19 | |
Chuck | ||
flat portion | ||
cover |
Chuck cover
Steel ball 7.0 Ring 21
Ring 21 
Guide washer
Conical
compression
spring
ASSEMBLING for BHR262, HR262D
Take the disassembling step in reverse.
Note: Be sure to place the flat portion of Ring spring 19 on Steel ball 7.0. (Fig. 4)
DISASSEMBLING for BHR262T, HR262TD
Fig. 5
Separate Tool holder set from Tool holder guide complete.
Remove Cap 35 with slotted screw- driver, then remove Ring spring 19 using 1R003 with 1R212.
Separate Chuck cover. Then remove Steel ball 7.0 while pressing down Stopper.
| Cap 35 | Chuck cover |
| 1R003 | |
|
| |
Tool holder set |
| 1R212 |
|
| |
Tool holder guide | Ring spring 19 | Stopper |
|
Steel ball 7.0
Stopper, Guide washer, Conical compression spring
Stopper Guide washer
Conical 
compression 
spring 
Flat washer 21 Tool holder
Remove Ring spring 21 | Remove Tool holder |
with 1R004 from Tool | together with Change |
holder guide side. Flat | ring from Change cover. |
washer 24, Leaf spring | And separate Change |
and Steel ball 5 can be | ring from Tool holder. |
disassembled. |
|
Ring spring 21 | Tool holder |
Flat washer 24 | Torsion spring 31 |
Leaf spring | Change ring |
| |
Steel ball 5 | Change cover |
|
After removing Torsion spring 31, Steel ball 6 can be separated from Tool holder.
Torsion spring 31
Steel ball 6 (2 pcs.)