P 9/22
Repair
[3]DISASSEMBLY/ASSEMBLY
[3]-3. Change lever
DISASSEMBLING
Fig. 19
While pushing Lock button into Change lever, turn Change lever a little over Drill mode position to lock it in place.
Insert slotted screwdriver between Change lever and Gear housing complete, then lever up Change lever.
Change lever
Drill mode
Lock button | slotted screwdriver |
|
ASSEMBLING
Fig. 20
Change plate can be seen through Change lever insertion hole of Gear housing complete. While hooking the thin pin of Change lever to Change plate from Hammer mode side, turn Change lever to Drill mode side.
Note: Change lever is incompletely fit to Gear housing complete in the above step.
Change plate
Hammer mode | Viewed from the upper side |
thin pin of Change lever
| (thick pin of |
|
Drill mode | Change lever) | Drill mode |
|
Fig. 21
While pushing Lock button into Change lever, fit Change lever completely to Gear housing complete.
Note: Be sure to check Change lever works properly after assembling.
Change lever
Lock button