Specifications, Symbols | Makita HR2470FT, HR2470T specification

ENGLISH (Original instructions)

SPECIFICATIONS

		Model		HR2470/HR2470F		HR2470T/HR2470FT
			Tungsten-carbide tipped bit		24 mm
	Concrete		Core bit		54 mm
Capacities			Diamond core bit (dry type)		65 mm
			Steel		13 mm
			Wood		32 mm
	No load speed (min-1)				0 - 1,100
	Blows per minute				0 - 4,500
	Overall length			370 mm		394 mm
	Net weight			2.9 kg		3.0 kg
	Safety class					/II

•Due to our continuing programme of research and development, the specifications herein are subject to change without notice.

•Specifications may differ from country to country.

•Weight according to EPTA-Procedure 01/2003

END201-5

Symbols

The following show the symbols used for the equipment. Be sure that you understand their meaning before use. ･ Read instruction manual.

･ DOUBLE INSULATION

･ Only for EU countries

Do not dispose of electric equipment together with household waste material! In observance of European Directive 2002/96/EC on waste electric and

electronic equipment and its implementation in accordance with national law, electric equipment that have reached the end of their life must be collected separately and returned to

an environmentally compatible recycling facility.

ENE043-1

Intended use

The tool is intended for hammer drilling and drilling in brick, concrete and stone as well as for chiselling work. It is also suitable for drilling without impact in wood, metal, ceramic and plastic.

ENF002-1

Power supply

The tool should be connected only to a power supply of the same voltage as indicated on the nameplate, and can only be operated on single-phase AC supply. They are double-insulated in accordance with European Standard and can, therefore, also be used from sockets without earth wire.

ENG102-3

Noise

The typical A-weighted noise level determined according to EN60745:

Sound pressure level (LpA) : 90 dB(A)

Sound power level (LWA) : 101 dB(A)

Uncertainty (K) : 3 dB(A)

Wear ear protection

ENG215-2

Vibration

The vibration total value (tri-axial vector sum) determined according to EN60745:

Work mode : chiseling function

Vibration emission (ah,CHeq) : 12.5 m/s2

Uncertainty (K) : 1.5 m/s2

ENG303-2

Work mode : hammer drilling into concrete

Vibration emission (ah,HD) : 15.5 m/s2

Uncertainty (K) : 1.5 m/s2

ENG301-1

Work mode : drilling into metal

Vibration emission (ah,D) : 4.5 m/s2

Uncertainty (K) : 1.5 m/s2

ENG901-1

•The declared vibration emission value has been measured in accordance with the standard test method and may be used for comparing one tool with another.

•The declared vibration emission value may also be used in a preliminary assessment of exposure.

WARNING:

•The vibration emission during actual use of the power tool can differ from the declared emission value depending on the ways in which the tool is used.