Makita HR2470FT, HR2470T Functional Description, Reversing switch action, Switch action

supplier safety data.

SAVE THESE INSTRUCTIONS.

WARNING:

DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to safety rules for the subject product. MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury.

CAUTION:

•Do not look in the light or see the source of light

directly.

To turn on the lamp, pull the trigger. Release the trigger to turn it off.

NOTE:

•Use a dry cloth to wipe the dirt off the lens of lamp. Be careful not to scratch the lens of lamp, or it may lower the illumination.

FUNCTIONAL DESCRIPTION

CAUTION:

•Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool.

Reversing switch action

B 1

A

1.Reversing switch lever

Switch action

2

1

1.Switch trigger

2.Lock button

007935

CAUTION:

•	Always check the direction of rotation before
	operation.
•	Use the reversing switch only after the tool comes
	to a complete stop. Changing the direction of
	rotation before the tool stops may damage the tool.

007933

CAUTION:

•Before plugging in the tool, always check to see that the switch trigger actuates properly and

returns to the "OFF" position when released.

To start the tool, simply pull the switch trigger. Tool speed is increased by increasing pressure on the switch trigger. Release the switch trigger to stop. For continuous operation, pull the switch trigger and then push in the lock button. To stop the tool from the locked position, pull the switch trigger fully, then release it.

Lighting up the lamps

•	If the switch trigger can not be depressed, check to
	see that the reversing switch is fully set to

position (A side) or(B side).

This tool has a reversing switch to change the direction

of	rotation. Move the reversing switch lever to
the	position (A side) for clockwise rotation or
the	position (B side) for counterclockwise rotation.

Changing the quick change chuck for SDS-plus

For model HR2470T/HR2470FT

The quick change chuck for SDS-plus can be easily exchanged for the quick change drill chuck.

Removing the quick change chuck for SDS-plus

For Model HR2470F, 2470FT

1. Lamp

1

007934

1

3

2

007944

1.Quick change chuck for SDS-plus

2.Change cover line

3.Change cover

5