Side grip (auxiliary handle)
16
3
45
2
007949
1.Grip base
2.Side grip
3.Loosen
4.Tighten
5.Teeth
6.Protrusion
To remove the bit, pull the chuck cover down all the way and pull the bit out.
| 1. | Bit |
1 | 2. | Chuck cover |
|
| |
2 |
|
|
007939
CAUTION:
•Always use the side grip to ensure operating safety.
Install the side grip so that the teeth on the grip fit in between the protrusions on the tool barrel. Then tighten the grip by turning clockwise at the desired position. It may be swung 360° so as to be secured at any position.
Bit grease
Coat the bit shank head beforehand with a small amount of bit grease (about 0.5 - 1 g).
This chuck lubrication assures smooth action and longer service life.
Installing or removing the bit
Bit angle (when chipping, scaling or demolishing)
1 | 1. Lock button | |
2. Action mode | ||
| ||
| changing knob | |
2 |
| |
007950 |
|
The bit can be secured at the desired angle. To change
1 2
003150
1. Bit shank
2. Bit grease
the bit angle, depress the lock button and rotate the action mode changing knob to the O symbol. Turn the bit to the desired angle.
Depress the lock button and rotate the action mode changing knob to the 
symbol. Then make sure that the bit is securely held in place by turning it slightly.
Clean the bit shank and apply bit grease before installing
the bit.
1
2
1.Bit
2.Chuck cover
007951
Depth gauge
1. Depth gauge
1
007938
Insert the bit into the tool. Turn the bit and push it in until it engages.
After installing, always make sure that the bit is securely held in place by trying to pull it out.
007952
7