003163 To remove the bit, pull the chuck cover down all the way and pull the bit out.
1
2
1.Bit
2.Chuck cover
|
| 003178 |
1 | 2 | 3 |
1.Chisel adapter
2.Clamp screw
3.Chisel
Using cold chisel or bull point
When using optional cold chisel or bull point, proceed as fol- lows.
1.Unplug the tool.
2.Remove the side grip from the tool.
3.Set the action mode changing knob to “rotation with hammering” symbol.
4.Install the cold chisel or bull point and then the chisel adapter (optional accessory) on the tool.
5.Rotate the cold chisel toward the direction suitable for your work. Then secure the cold chisel and chisel adapter by using the clamp screw on the chisel adapter.
6.Turn the action mode changing knob to “hammering only” symbol. Now you can use the cold chisel or bull point.
CAUTION:
•Always use ’’hammering only’’ action when the chisel adapter is installed on the tool. If you use ’’rotation with hammering’’ or ’’rotation only’’ action, a malfunction and damage to the tool will result.
003181 |
1 |
2 |
1.Clamp screw
2.Depth gauge
Depth gauge
The depth gauge is convenient for drilling holes of uniform depth. Insert the depth gauge into the hole in the grip base. Adjust the depth gauge to the desired depth and then tighten the clamp screw to secure the depth gauge.
NOTE:
•The depth gauge cannot be used at the position where the depth gauge strikes against the tool body.
9