Makita HR2400 instruction manual Side grip auxiliary handle, Bit grease optional accessory

	003143	Side grip (auxiliary handle)
2		The side grip swings around to either side, allowing easy
		handling of the tool in any position. Loosen the clamp screw
		on the side grip and swing the side grip to the desired posi-
		tion. Then tighten the clamp screw to secure the side grip.

1

1.Side grip

2.Clamp screw

1

003150

2

Bit grease (optional accessory)

Coat the bit shank head beforehand with a small amount of bit grease (about 0.5 -1 g; 0.02 - 0.04 oz.). This chuck lubri- cation assures smooth action and longer service life.

Installing or removing the bit

Clean the bit shank and apply bit grease before installing the bit.

1.Bit shank

2.Bit grease

003158

1

2

1.Bit

2.Chuck cover

Insert the bit into the tool. Turn the bit and push it in until it engages.

If the bit cannot be pushed in, remove the bit. Pull the chuck cover down a couple of times. Then insert the bit again. Turn the bit and push it in until it engages.

After installing, always make sure that the bit is securely held in place by trying to pull it out.

8