Installation Instructions
STEP 5 INSTALL DUCT TRANSITION WITH DAMPER
Bumper Pads
Duct
Transition
Attachment
Screws
Screws C
IMPORTANT: Remove shipping tape from damper and check that damper moves freely.
•Place the transition piece over the hood exhaust and secure with 4 Screws C provided.
•Use duct tape to seal the connection. Check to be sure the damper moves freely.
STEP 6 INSTALL HOOD
Note: THREE PEOPLE ARE REQUIRED TO COMPLETE THIS INSTALLATION!
1/4" Gap
Attachment
Keyholes
•Back out the hanging screws on the bottom of the support frame to a 1/4" gap.
•Lift the hood up to the support frame. Carefully align the hood keyhole to the screws on the support frame. Slide the hood to engage the keyhole slots.
•Tighten the screws.
Install
2 Safety
Screws
Screws C
•Install safety screws into the top of the hood as shown.
•Check hood level in both directions.
STEP 7 CONNECT DUCT
•Loosen duct collar and slide down to cover gap between transition and house duct.
Tighten collar
screws and tape all joints.
•Seal all connections with duct tape.
Slide Duct
Collar Down
to Cover Gap
Note: Do not drive screws through this duct connection. Doing so will prevent proper damper operation.
15