Installation Preparation
TOOLS AND MATERIALS REQUIRED
(NOT SUPPLIED) |
| 7/16" Pivoting |
| hex socket with 4" | |
|
| |
|
| and 6" extensions |
| Duct tape | Wire cutter/stripper |
|
| |
Pencil and tape measure |
|
|
|
| Safety glasses |
Spirit level |
| Wire nuts |
|
| |
|
| Flashlight |
Hammer
Electric or battery operated drill
Key Hole Sawand 3/16", bits, Phillips and Flat Blade Screwdriver bits.
10" round metal duct, length to suit installation.
Phillips and flat blade screwdrivers
Saber saw | Strain relief for | |
or Sawsall | ||
junction cover. | ||
|
Step ladder
120V 60Hz. 15 or 20 Amp,
Carpenter’s square | Pliers | Metal Snips |
REMOVE THE PACKAGING
•Remove the parts packages and packing materials.
•Lift the hood out of the box.
IMPORTANT: Lift the hood by grasping the outside edges of the exhaust opening on the top.
| Parts |
Parts | Parts |
| Hood |
| Motor |
| Mounted |
| on Skid |
Shipping Carton
•Carefully, lay the hood on its side. A support frame is secured to the inside top of the hood. Remove the attachment screws at the outside top. Discard screws.
•Grasp the support frame inside the hood with both
hands and carefully rotate out of the opening.
Be careful not to scratch the hood.
•Place the hood on a protective surface to prevent scratches and damage to the stainless steel finish.
•The hood motor is shipped secured to the skid with 4 screws. Locate and remove 2 screws on each side of the motor. Discard the shipping skid and screws.
8