Installation Instructions
STEP 8 CONNECT ELECTRICAL
Verify that power is turned off at the source. | • Install strain relief onto the knockout of the junction | |
WARNING: If house wiring is not | box. | |
• Insert house wiring through strain relief and tighten. | ||
• Use wire nuts to connect incoming ground to green, | ||
by the installer. When house wiring is aluminum, be | ||
white to white and black to black. | ||
sure to use UL approved | ||
• Push wires into junction box and replace cover. Be sure | ||
wires are not pinched. | ||
| ||
ATTENTION – Si le câblage de la |
| |
maison n’est pas du type à deux fils avec un fil de |
| |
terre, l’installateur doit fournir un circuit de terre. |
| |
Quand les fils de la maison sont en aluminium, il |
| |
prendre soin d’utiliser de la pâte antioxidation |
| |
approuvée par UL et des connecteurs pour |
| |
|
STEP 9 INSTALL THE MOTOR
Outlet
Attachment | Spring | ||
Slot | Clip | ||
|
| Attachment Screw | |
|
| and Washer | |
|
|
|
|
|
|
|
|
Top
IMPORTANT: Connector ends are designed to mate only one way. Match flat and round connectors as shown.
Screw F
Attachment | Spring | Junction Box |
Slot | Clip |
•From the inside of the hood, slip motor into the attachment slot on the left.
•Rotate motor upwards until it snaps into the spring clip on the right.
•Secure the motor to the hood with the machine screw and lock washer (Screw is marked with red paint.)
•Plug blower cable into the connector on the blower.
•Plug cable at the top of the hood into the junction box connector. Route cable so it won’t be pinched or damaged when the duct cover is lowered.
16