Installation Instructions
STEP 2 MOUNT TEMPLATE
• Select the template for your hood size. |
|
• Align the template with the marks on the ceiling and |
|
tape in place. |
|
– Be sure the template is oriented correctly, |
|
with the front of the hood. |
|
• Use a plumb to check to be sure the mounting |
|
holes will provide parallel alignment with the |
|
countertop below. |
|
• Center punch all hole locations. |
|
• Drill pilot holes in the 4 screw locations. Use a |
|
3/16” bit and drill approximately |
|
• Drive 4 Hex head wood screws (Screws A) into |
|
the center of the ceiling joists and cross framing. |
|
Leave a 1/4" gap to allow the screw head to |
|
engage the keyhole slots on the support frames. |
|
• Cut the | Screws A |
rock. |
|
1/4" Gap
STEP 3 SIZE AND INSTALL DUCTWORK
•Measure from house duct flange to bottom of support frame. Subtract
•Cut the 10” duct length to size.
•Secure duct to house ducting with sheet metal screws.
•Seal all connections with duct tape.
•Attach the duct collar loosely, about 1" from the bottom of the duct using Screws B.
House
Duct
Duct
Length
Duct
Duct
Collar
Screws B
13