Installation Instructions
STEP 4 INSTALL ACCESSORY (OR SUPPLIED) SUPPORT AND DUCT COVERS
| Install | Adjust | |||||
| Frame to | ||||||
Safety Screw | |||||||
nstallation | |||||||
on Each Side | |||||||
Height | |||||||
|
|
|
|
|
|
| |
|
|
|
|
|
|
| |
|
|
|
|
|
|
| |
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
Install Small Pan Head
Screws on Each Side
Top Duct
Cover
Screws D
Bottom Duct
Cover
Install Stop
Screw
Screws E
Stop Screw
Storage Location
Install supplied support frame OR telescoping accessory frame
•Hang the supplied support frame or telescoping accessory frame to the ceiling joists and cross framing on the 4 hex head screws by engaging the keyhole slots on the frame.
•Check to be sure the support frame is level, vertically and horizontally.
•Tighten the hex head screws securely.
•Install safety screws, (Screws E) on each side of the frame.
Adjust telescoping accessory frame to length
•Remove the 8 frame adjustment screws. Adjust the lower support up or down to the
•Slide the top (inner) accessory duct cover up and over the frame. Secure the duct cover to the frame as shown using Screws D.
•Locate and remove the safety stop screw. Slide bottom duct cover up and over the top duct cover. Align bottom duct screw hole to the hole in the frame. Hold the duct cover in place while installing screw.
CAUTION: The stop screw must be installed. Failure to do so could result in personal injury or damage to the duct cover. The stop screw will prevent the lower duct from sliding down while completing the installation.
PRUDENCE
Il faut mettre en place la vis de butée afin d’éviter des blessures ou d’endommager l’enceinte du conduit. La vis de butée empêche l’enceinte inférieure du conduit de descendre pendant l’installation.
Secure house wiring
•Route house wiring through the ceiling and pull a length to reach the hood junction box, approximately 6” below the support. Tape to the right side of the support frame.
IMPORTANT: Again, check to be sure the support is level in both directions. There is no way to level the hood after the hood is secured to the frame.
14