ASSEMBLY
CAUTION:
•Always be sure that the tool is switched off and unplugged before carrying out any work on the tool.
003146
1
2
1.Side grip
2.Grip base
003149
003153
1
2
1.Red dot (Tool holder)
2.Rde dot (Tool retainer)
Side grip (auxiliary handle)
For maximum control and safer operation, always use the side grip with this tool. The side grip swings around to either side, allowing easy handling of the tool in any position. Loosen the side grip by turning it counterclockwise, swing it to the desired position and then tighten it by turning clock- wise.
The side grip can also be installed in the position shown in the figure. Remove the side grip from the grip base by turn- ing the side grip counterclockwise. Screw the side grip on either side of the tool, whichever is convenient.
Installing or removing the bit
Press in the tool retainer and turn it until the red dots on the tool retainer and the tool holder are aligned. Release the tool retainer.
2 
003154
1
3
Insert the bit into the tool holder as far as it will go. Press in the tool retainer and turn it a full 180 degrees. Then release it to secure the bit.
To remove the bit, follow the installation procedure in reverse.
1. Tool retainer
2. Turn 180°
3. Press in
8