Makita HM0870C, HM0871C dimensions Specification, Standard equipment, Optional accessories

TECHNICAL INFORMATION

Models No. HM0871C, HM0870C

PRODUCT P 1/ 17

Description Demolition Hammers

CONCEPT AND MAIN APPLICATIONS

Models HM0871C and HM0870C are 5kg-class demolition hammers adapted for SDS-MAX bits, and developed from HM0860C, featuring: Same high work efficiency as HM0860C

Higher durability achieved by using ball bearing for crank section

AVT* for reduced vibration during chipping (HM0871C only)

Suppression of motor speed during no-load for reduced vibration when idling

Listed below are the specification differences between the two models.

Model No.	HM0871C	HM0870C
AVT*
Vibration absorbing handle	Yes	No
Suppression of motor speed during no-load

L

H

W

[The image above is HM0871C.]

Dimensions: mm (")
Model No.	HM0871C		HM0870C
Length (L)	466	(18-3/8)	449 (17-3/4)
Width (W)	116	(4-9/16)	109 (4-1/4)
Height (H)		230 (9)

*Anti-Vibration Technology using Active dynamic vibration absorber

Specification

	Voltage (V)		Current (A)		Cycle (Hz)	Continuous Rating (W)		Max. Output (W)
						Input	Output
	110		12		50/60	1,100	450	1,200
	120		10		50/60	---	450	1,200
	220		5.8		50/60	1,100	500	1,200
	230		5.8		50/60	1,100	500	1,200
	240		5.8		50/60	1,100	500	1,200
	Model No.					HM0871C		HM0870C
	Impacts per min: min-1= ipm						1,100 - 2,650
	Shank type					Adapted for SDS-MAX bits
	Shank diameter: mm (")						18 (11/16)
	Vibration	AVT (Anti-Vibration Technology using				Yes		No
			Active dynamic vibration absorber)
	absorption
		Vibration absorbing handle				Yes		No
		Variable speed control by dial					Yes
	Electronic	Soft start					Yes
	control	Constant speed control					Yes
		Suppression of motor speed				Yes		No
		during no-load
	Double insulation						Yes
	Power supply cord: m (ft)					Europe, Hong Kong, Korea: 4.0 (13.1);
						Brazil: 2.0 (6.6); Other countries: 5.0 (16.4)
	Net weight*1: kg (lbs)					5.6 (12.4)		5.1 (11.1)
	Net weight*2: kg (lbs)					5.8 (12.8)		5.3 (11.6)
*1 Weight according to EPTA-Procedure 01/2003, with bar-shaped Side handle.
*2 Weight according to EPTA-Procedure 01/2003, with D-shaped Side handle.
Standard equipment
Side handle (Bar- or D-shaped)				1	Plastic carrying case		1
Bit grease				1	Cleaning cloth	..................................	1

Note: The standard equipment for the tool shown above may vary by country.

Optional accessories

Bull points	Grooving chisel	Shank (for Bushing tool and Rammer)
Cold chisels	Clay spade	Grease vessel (containing 30g hammer grease)
Scaling chisels	Bushing tool	Side handle (Bar-shaped/ D-shaped)
Scaling chisel (for Tile)	Rammer	Safety goggles
		Hammer service kit