P 8/ 17
Repair
[3]DISASSEMBLY/ASSEMBLY
[3]-4 Piston, Striker, Cylinder (cont.)
DISASSEMBLING
(4)Separate Cylinder section from Barrel. The parts on Tool holder side can be removed from Cylinder 32 as per the right illustration in Fig. 17.
Fig. 17
Remove Cylinder section by tapping Barrel using plastic hammer. Pay attention to the tapped position.
Ring 20, Rubber ring 20, Flat washer 23, Guide ring, Slide sleeve are removed from Cylinder section.
Cylinder Section
Barrel
Ring 20
| Rubber ring 20 | fit to the long drum side |
| of Impact bolt | |
| Flat washer 23 | |
|
| |
| Guide ring |
|
| Slide sleeve | |
Barrel | Cylinder 32 | |
| ||
(5)Pressing down Ring 36, remove Ring spring 34 (A) from Groove (A) on Cylinder 32 with 1R291.
The components of Cylinder section can be separated by removing Ring spring 34 (B) and (C). (Fig. 18.)
Fig. 18
| Ring spring 34 | Cylinder 32 |
| |
| groove(A) |
| Ring 36 | |
| groove(B) |
| ||
| groove(C) | Compression | ||
|
|
| ||
1R291 | Ring spring 34 (A) | spring 37 | ||
Cylinder guide | ||||
| ||||
Ring 36 | Groove (A) | Ring spring 34 (B) | O ring 46 | |
on Cylinder 32 |
| |||
Compression | Ring washer 34 | |||
|
| |||
spring 37 |
|
| (See Fig. 15.) | |
Cylinder guide |
| Ring spring 34 (C) | ||
|
|
| ||