Miller Electric MOG-400, MOG-300, MOG-350, MOG-250, MOG-Pak, RGC manual Amperage Controls

4-5. Amperage Controls

CAUTION

ARCING can damage switch.

•Do not change position of any Amperage control or switch while welding or under load. Arcing inside switch can damage contacts, causing switch to fail.

1 Coarse Amperage Control

Use control to select coarse weld amperage output.

To set amperage using only the Fine Amperage control, place Coarse Amperage control in Off position.

2 2-1/2 Ampere Switch (Optional)

Use switch to add 2-1/2 amperes to weld output.

To add 2-1/2 amperes to weld output, place switch in Off position.

For remote amperage adjustment, place switch in Off position.

3 Fine Amperage Control

Use control to add amperage, in 5 ampere steps, to weld output.

For remote amperage adjustment, place control in Off position.

1

2

In Example:

Total Amperage Output = 122.5 A

(100 A + 2.5 A)

3

OM-808 Page 18