Miller Electric S-74DX manual Adjust Control, Sequence Push Button

6-8. Adjust Control

1

Adjust

1 Adjust Control

The Adjust control is used to change various sequence parame- ters, and to select various se- quences. Refer to the section for the function in question for informa- tion related to using the Adjust con- trol.

1

Non-CE Models CE Models

6-9. Sequence Push Button

3	Start	3
	Crater
	Pre/Postflow
		2
		1
	Sequence

Non-CE Models

	1	Sequence Push Button
	2 Sequence Push Button LED
	3	Welding Sequence LEDs
	Start	Weld	Crater
2		Time
	Time		Time
1	Preflow		Postflow
	Time
			Time
	Welding Sequence Diagram
CE Models

.For more information on Setting Sequence Parameters see Section 7-1.

•The Sequence push button allows the selection of welding sequences. Five weld- ing sequences are available. The default sequence is the Weld sequence. The Weld sequence is active on power up. Three welding sequence LEDs are located above the Sequence push button: Start, Crater, and Preflow/Postflow. The applicable LED illuminates to indicate which welding se- quence is active.

•The LED illuminates to indicate that a weld- ing sequence display mode other than Weld is activate. Welding sequences other than Weld must be set prior to initiating the arc. When the unit enters a welding state, all se- quence display modes are terminated and

the weld display mode is activated.

If zero time is programmed for a timed se- quence except for Weld, that sequence will be skipped.

•In the weld sequence display mode the Se- quence push button LED is Off. When the Sequence push button is pressed, the Se- quence push button flashes and the Start LEDs flash. In this condition, the unit is in the Start sequence display mode, and Start se- quence parameters are shown in the dis- plays.

•When the Sequence push button is pressed a second time, the Crater sequence LED flashes. The Sequence push button LED re- mains flashing. In this condition, the unit is in the Crater sequence display mode, and Crater sequence parameters are shown in the displays.

•When the Sequence push button is pressed a third time, the Preflow/Postflow sequence LED flashes. The Sequence push button LED remains flashing. In the Preflow display mode the upper display shows the preflow time and the lower display indicates the ab- breviation PRE, to inform the operator that preflow time is displayed. If the upper dis- play push button is pressed, the Adjust con- trol can be used to adjust preflow.

If the lower display push button is pressed, the Adjust control can be used to select between preflow PRE and postflow POST. When POST is selected, the upper display can be used to specify postflow time.

•When the Sequence push button is pressed a fourth time, the unit returns to the welding sequence display mode.

OM-1500-9 Page 21