SECTION 5 − MAINTENANCE & TROUBLESHOOTING
Routine Maintenance |
| |
| Y Disconnect power | . Maintain more often |
| before maintaining. | during severe conditions. |
| 3 Months |
|
| Replace |
|
| Damaged Or | Replace Damaged |
| Unreadable | Gas Hose |
| Labels |
|
|
| Repair Or Replace |
|
| Cracked Cables |
|
| And Cords |
| 6 Months |
|
| Clean | Blow Out Or |
| Drive | |
| Vacuum Inside | |
| Rolls | |
|
|
5-2. Overload Protection And Thermostat Protection
Y Turn Off wire feeder and welding power source. Stop
engine on welding generator.
1 | 1 Circuit Breaker CB1 |
CB1 protects wire feeder from over- load. Correct problem and reset CB1.
Close and latch door.
CB1 | Thermostat Protection |
Unit has internal thermostat protec- tion and will not feed wire if over- heating occurs (see Section
Internal Side View
804