Simer Pumps 2325, 2360, 2385 owner manual Read and Follow Safety Instructions, General Safety

Safety 2

READ AND FOLLOW

SAFETY INSTRUCTIONS!

This is the safety alert symbol. When you see this

symbol on your pump or in this manual, look for one of the following signal words and be alert to the potential for personal injury.

warns about hazards that will cause serious personal injury, death or major property damage if ignored.

warns about hazards that can cause serious personal injury, death or major property damage if ignored.

warns about hazards that will or can cause minor personal injury or property damage if ignored.

The label NOTICE indicates special instructions which are important but not related to hazards.

GENERAL SAFETY

Carefully read and follow all safety instructions in this manual and on pump.

Keep safety labels in good condition.

Replace missing or damaged safety labels.

To avoid serious injury and/or property damage, read and follow these rules and instructions carefully.

1.Pump is designed for use with clean, cold, fresh water. Pump water only with this pump.

2.Do not lift pump by power cord at any time. Attempting to lift or support the pump by the power cord can damage the cord and cord connections, and will void warranty. Always lift the pump by the lifting handle.

3.Meet National Electrical Code, Canadian Electrical Code, and local codes for all wiring.

4.Installation must comply with all local codes per- taining to utility pumps.

5.Know the pump application, limitations, and poten- tial hazards.

6.Disconnect the power before servicing.

7.Release all pressure within the system before servic- ing any component.

8.Drain all water from the system before servicing.

9.Secure the discharge line before starting pump. An unsecured discharge line will whip, possibly causing personal injury and/or property damage.

10.Check hoses for weak or worn condition before each use, making certain that all connections are secure.

11.Periodically inspect the pump and system compo- nents. Keep the pump inlet free of debris and foreign objects. Perform routine maintenance as required.

12.Personal Safety:

a.Wear safety glasses at all times when working with pumps.

b.Keep work area clean, uncluttered and properly lighted – replace all unused tools and equipment.

c.Keep visitors at a safe distance from work area.

d.Make workshop child-proof – with padlocks, mas- ter switches, and by removing starter keys.

13.This equipment is only for use on 115 volt (single phase) and is equipped with an approved 3-conduc- tor cord and 3-prong, grounding-type plug.

Hazardous voltage. Can shock, burn or cause death. To reduce risk of electric shock, pull plug before servicing. This pump has not been investigated for use in swimming pool areas. Pump is supplied with a grounding conductor and grounding-type attachment plug. Be sure it is connected only to an individual branch circuit with a properly grounded grounding-type receptacle. Where a 2-prong wall receptacle is encountered, it must be replaced with a properly grounded 3-prong receptacle installed in accordance with codes and ordinances that apply.

14.Make certain power source conforms to requirements of your equipment.

15.Protect the electrical cord from sharp objects, hot sur- faces, oil, and chemicals. Avoid kinking cord. Replace or repair damaged or worn cords immediately.

16.Do not touch an operating motor. Modern motors are designed to operate at high temperatures.

17.Do not handle pump or pump motor with wet hands or when standing on wet or damp surface, or in water.

18.Do not use in water where fish are present.

For parts or assistance, call Simer Customer Service at 1-800-468-7867 /1-800-546-7867