2-7. Inductance Selection (200 And 300 Ampere Models)
2
1
5
4
3
6 | 7 |
1 Stabilizer Z
Tapped stabilizer Z is factory connected to the stabilizer tap which suits most GMAW applications.
Stabilizer Z controls the inductance applied to the weld current. To in- crease inductance and wet out the weld puddle, connect to stabilizer Z ending.
To change inductance proceed as follows:
2Lead 25
3Stabilizer Z Tap
4Stabilizer Z Ending
5Lead 26
To increase inductance, connect lead 26 to stabilizer ending and secure.
Reinstall side panel.
6Typical Weld Bead Using The Tap Stabilizer Connection
Use the tap Stabilizer connection to obtain arc type and weld bead suit- able for some mild steel applica- tions.
7Typical Weld Bead Using The End High Stabilizer Connection
Use the end Stabilizer connection to reduce weld bead crowning, and spread the weld puddle.
Weld Bead Using The Tap Stabilizer | Weld Bead Using The End Stabilizer |
Connection With 17 Volts, 100 Amps | Connection With 17 Volts, 100 Amps |
3/8, 7/16 in
3/8 in