Miller Electric AA40GBU Typical Equipment Location, Installing Drive Rolls, Installation, Removal

3-3. Typical Equipment Location

4

3

2

1

5

6

					7
1	Welding Power Source	4	Weld Control	6	Wire Drive Assembly
2	Gas Cylinder	5	Spool Support	7	Automatic Welding Gun
3	Side Beam				ST-131 138-A

3-4. Installing Drive Rolls

4

3

2

1

1Pressure Assembly Door

2Drive Roll

3Ejector Button

4Drive Roll Carrier

Installation

Open pressure assembly door.

Align drive roll slots with three lobes on drive roll carrier.

Insert drive roll onto carrier. Drive roll will snap into place.

Removal

.Remove PD wire guide before removing lower drive rolls.

Lift up drive roll swing arm and press ejector button in middle of drive roll carrier.

.If ejector button does not re-

turn to normal position (out), install a drive roll and ejector button will pop out.

804 187-A

OM-227 674 Page 10