Broan QTXE110SFLT warranty Install Grille, Warranty

Page 4

MODEL QTXE110SFLT

INSTALL GRILLE

SERVICE PARTS

Page 

6. Finish ceiling.

Install ceiling material. Cut out around housing.

7. Plug in wiring.

Plug wiring into the proper receptacles.

TAB

8. Attach grille to

9. Push grille against

housing.

ceiling.

Squeeze grille springs and insert them into slots on each side of housing.

10.Remove light lens.

Carefully insert a small flat-blade screwdriver be- tween grille and lens. Pry lens out.

11. Install light bulbs.

Insert fluorescent bulb (supplied) into its socket. Purchase a 4W incandes- cent night-light bulb and

Replacement parts can be ordered on our website.

Please visit us at www.broan.com

SERVICE NOTE

To remove Blower Assembly: Unplug motor (7). Remove thumbscrew (21) from motor plate (9) flange. Find the single tab on the motor plate (lo- cated next to the receptacle). Push up near motor plate tab while pushing out on side of housing. Or insert a straight-blade screwdriver into slot in housing (next to tab) and twist screwdriver.

WARRANTY

screw it into its socket. Replace lens.

Key No.

Part No.

Description

1

97016466

Housing

2

97016450

Duct Connector-6”

3

98010102

Wiring Plate

4

99170245

Screw, #8-18 X .375

BROAN THREE YEAR LIMITED WARRANTY

Broan warrants to the original consumer purchaser of its products that such products will be free from defects in materials or workmanship for a period of three years from the date of original pur- chase. THERE ARE NO OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.

During this three-year period, Broan will, at its option, repair or replace, without charge, any product or part which is found to be defective under normal use and service.

THIS WARRANTY DOES NOT EXTEND TO FLUORESCENT LAMP STARTERS AND TUBES. This warranty does not cover (a) normal maintenance and service or (b) any products or parts which have been subject to misuse, negligence, accident, improper maintenance or repair (other than by Broan), faulty installation or installation contrary to recommended installation instructions.

The duration of an implied warranty is limited to the three-year period as specified for the express warranty. Some states do not allow limitation on how long an implied warranty lasts, so the above limitation may not apply to you.

BROAN’S OBLIGATION TO REPAIR OR REPLACE, AT BROAN’S OPTION, SHALL BE THE PURCHASER’S SOLE AND EXCLUSIVE REMEDY UNDER THIS WARRANTY. BROAN SHALL NOT BE LIABLE FOR INCIDENTAL, CONSEQUENTIAL OR SPECIAL DAMAGES ARISING OUT OF OR IN CONNECTION WITH PRODUCT USE OR PERFORMANCE. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation may not apply to you.

This warranty gives you specific legal rights, and you may also have other rights, which vary from state to state. This warranty supersedes all prior warranties.

To qualify for warranty service, you must (a) notify Broan at the address or telephone number stated below, (b) give the model number and part identification and (c) describe the nature of any defect in the product or part. At the time of requesting warranty service, you must present evidence of the original purchase date.

Broan-NuTone LLC Hartford, Wisconsin www.broan.com 800-558-1711

5

97017086

Wire Panel/Harness Assembly *

6

99020284

Blower Wheel

7

99080580

Motor

8

99100491

Isolator (4 req’d)

9

97017084

Motor Plate & Control Assembly *

10

99250959

Washer #8 (4 req’d)

11

99260558

Nut, Hex Lock #8-32 (4 req’d)

*

97017088

Blower Assembly *

12

97016864

(includes key nos. 6 thru 11)

Ballast Assembly *

13

99260423

Nut, Hex #8-32 (2 req’d)

14

97016966

Grille Assembly *

15

99140199

(includes key nos. 15, 17 & 20)

Grille Spring (2 req’d)

16

99271358

Bulb, 42W Fluorescent

17

99111345

Lens

18

99111293

Spacer (2 supplied)

19

SQTHB1

Hanger Bar Kit

20

99271344

Sensor Wire Harness

21

99420665

Thumbscrew, #8-18 x .375

* Parts not listed are included with Assembly.

Order service parts by “Part No.” - not by “Key No.” 99044057D

Image 4
Contents Read and Save These Instructions Cleaning & MaintenanceOperation Install Housing & Duct Typical InstallationsPlan the Installation Connect Wiring Attach damper/ duct connectorInstall Inch round duc Twork Connect electrical wiringInstall Grille WarrantyPrecaución LEA Y Conserve Estas InstruccionesLimpieza Y Mantenimiento Instalaciones Típicas Instale LA Cubierta Y EL ConductoPlanifique la conexión eléctrica 1a.Instale la cubierta en las viguetas o viguetasConexión Eléctrica PulgConecte los cables eléctricos Acople el conectador del regulador de tiro/conductoGarantía