Zebra Technologies Q3DLUBA000002 Platen/Gear Kits, QL320/320 Plus- AN16861-013 & AN16861 014

Platen/Gear Kits, QL320/320 Plus- AN16861-013 & AN16861-

014

You must use an ESD strap and work at a properly grounded workstation (antistatic mat or tray). All electronic components must be placed on an ESD protective tray. If stored, any elec- tronic components must be placed in antistatic bags.

NOTE: AN16861-035 and -036 are used on QL 320 units built prior to 1/20/03. Platen replacemnt proce- dures are the same for both versions.

Removing the Gear and Platen

1.Open the Media Cover.

2.Pry out the gear-end of the Platen and remove the Platen.

Installing the Gear and Platen

1.Align the flats on the Platen shaft with the hole in the Gear. The rib molded on the Gear must face outboard.

2.Install the Platen with Gear in the Inner Cover as shown.

Insert this end first. Platen

Gear 64P, 24T

Rib faces outboard

Installing the Scraper

If the printer uses a scraper and it is not installed, snap the Scraper into the Media Cov- er. The pins on the Scraper fit into the mounting holes for the Peeler Bar. The Scaper is used with linerless media only.

Scraper

RMAN-QLS-002 rev. A Repair Procedures • 2-58 •