Zebra Technologies Q4DLU1B000000, Q3DLUBA000002 manual Latch, QL 320/ QL 320 Plus- AN16861-025

Latch, QL 320/ QL 320 Plus- AN16861-025

You must use an ESD strap and work at a properly grounded workstation (antistatic mat or tray). All electronic components must be placed on an ESD protective tray. If stored, any elec- tronic components must be placed in antistatic bags.

Installing the Latch

1.Slide the Latch Shaft in the Printer Frame until the end is flush to the frame as shown. Slide the Latch Spring over the end of the Shaft as shown.

Slide the Shaft, Latch until
this end is flush with the	Latch Spring
Printer Frame.

Note: leg of the Torsion Spring is captured by this feature on the Printer Frame.

2.Slide the Latch Assembly over the right end of the Latch Shaft, holding it at an angle as shown, and then rotate the Latch down into the Printer Frame assem- bly, capturing the other leg of the Latch Spring.

Slide the Latch Shaft back into place until this end is flush with the Latch.

4.Secure the Latch Assembly. Line the left side of the latch assembly up with the hole for the Latch Shaft. Slide the Latch Shaft back to the left until both ends of the Shaft are flush with the outside of the Latch.

• 2-95 • RMAN-QLS-002 rev. A Repair Procedures