Zebra Technologies Q3DLUBA000002 Media Support Disks, QL Series, Remove the Media Support Disks

Media Support Disks, QL Series

Model	Kit	Media Type
QL 220/220 Plus	AN16972-005	Linered
QL 320	AN16861-030/-	Linered
	031
QL320/320 Plus &	AN16753-026	Linerless
QL420/420 Plus
QL420/420 Plus	AN16753-002	Linered

Tools Needed

#1 Phillips head screwdriver

Remove the Media Support Disks

1.Turn off the unit, open the Media Cover and remove any media loaded in the printer. (Refer to User’s Manual.)

2.Remove the existing Support Disks by removing the screw and flat washer se- curing them to the Media Supports.

Install new Media Support Disks

Media Support Disks for linered media are smoke colored. Media Support Disks for linerless media are colorless (clear). Both are assembled the same way.

1.Determine Media Core Size. Determine which media core size you will be us- ing. The media core width is set by flipping the media disks so that the sup- ports for the desired core size faces towards the inside of the printer.

Printers using media with a 1 3/8” core must have the Media Disks adjusted to use this media.

Screw

Flat Washer	Media Disks adjusted for 3/4”
	cores (standard configuration)

Media Support Disk

Media Disks adjusted for 1 3/8” cores

RMAN-QLS-002 rev. A Repair Procedures • 2-54 •