Zebra Technologies Q3DLUBA000002, Q4DLU1B000000 manual Equipment Required, Running The Software

Using Label Vista

Equipment Required

1.A computer with the following minimum configuration:

• Pentium CPU

• 256 MB RAM

• 1.44 MB Floppy Drive

• 1 GB Hard Drive

• CD-ROM drive

• SVGA 14 in.monitor and SVGA card

• 2 Serial Ports

• USB Port

• Windows 95/9, NT or 2000

• Unit Test Software version 3.3 or higher installed with the “euro” configuration.

2.A bar code scanner, using either RS232 (serial) keyboard “wedge” or USB com- munications. (Example: Symbol Model LS1908 series)

3.Serial Interface Cable part number AK18350-1 (or a Zebra approved equivalent).

4.Spare batteries, charger and test media specific to the printer. Refer to the table in the “Tools and Supplies” topic in Section 2 of this manual.

5.Sensor calibration swatches: p/n AA15417-1 (gray) and p/n AA15417-2 (white) These swatches are included in Spares Kit AN16753-029C.

Running The Software

CAUTION: DO NOT disconnect the communications cable at any time during the Unit Test procedure unless prompted to do so by the software!

Certain replacement procedures in this manual will require running the test procedure to verify a repair. It is recommended that you perform the entire unit test sequence for these procedures to verify all printer functions after the replacement.

To Start

•Launch the Unit Test Application.

•Plug the Serial Interface Cable into the printer’s communication port.

•Follow the on-screen instructions.

• 1-11 • RMAN-QLS-002 rev. A