Zebra Technologies Q3DLUBA000002, Q4DLU1B000000 Set New Parameters, Installing the Upper Housing

Installing the Upper Housing

1.Position the Upper Housing onto the Lower Housing. If installing a Wirelss Module (Kits AN 16972-016, -017, or 018) line up the Wireless Module connector with the connector on the MLB.

2.Position the D-Rings between the Upper Housing and Lower Housing as shown and install the (2) 4-40 x 1-1/4 Socket Head Screws.

4.Install the 4-40 x 3/16 Phillipps Screw from the Battery Compartment.3. Install the Battery Pack.

Set New Parameters

If you are replacing a WLAN module, you can now use the Network setup wizards in Label Vista 2.8 or higher. They are found under the Network Setup menu. Again you are urged to refer to the on-line help before you use these wizards, to determine what information you will need to set these parameters.

If you have any questions about network settings you should contact the system admin- istrator for the LAN where the QL series printer will be operating.

Installation of the Bluetooth module allows the advanced user to set many of the Bluetooth parameters through the use of the “get, set, do” commands outlined in Sec- tion 14 of the Programming Manual (revision “L” or higher). These commands are acces- sible only with printer applications of revision 40 or higher.

RMAN-QLS-002 rev. A Repair Procedures • 2-62 •