Zebra Technologies Q3DLUBA000002, Q4DLU1B000000 manual RMAN-QLS-002 rev. a Repair Procedures

Latch Shaft.

6.Press The Latch Shaft Into Position. Press the Latch Shaft so that the ends are flush with the sides of the Latch Assembly.

7.Remove the tool from between the Latch Lock and the Printer Frame.

8.Apply SuperLube to the bearing points on each end of the Latch Lock where shown in details.

9.Test the Latch. Press the Latch Lock Button. The latch assembly should pop open and be held in position by the Latch Spring.

10.Close the latch assembly, and ensure that the Latch Lock snaps back into posi- tion and the latch Assembly is locked in place.

Apply Super-Lube to	Latch Assembly
inside surface
	Latch Shaft

Latch Spring

Apply Super-Lube to gray areas

Apply Super- Lube to gray area

Insert 3/32” Hex

Driver or Spare

Peeler bar

RMAN-QLS-002 rev. A Repair Procedures • 2-94 •