Zebra Technologies Q4DLU1B000000, Q3DLUBA000002 Platen/Gear Kits, QL220/QL 220 Plus AN16972-008

Peeler Bar

Platen/Gear Kits, QL220/QL 220 Plus AN16972-008 & -009

Removing the Gear and Platen

1.Open the Media Cover.

2.Pry out the gear-end of the Platen and remove the Platen.

Installing the Gear and Platen

1. Align the flats on the Platen shaft with the hole in the Gear. The rib molded on the Gear must face outboard.

2. Install the Platen with Gear in the Inner Cover as shown.

AN16792-008- Installing the Peeler Bar

Platen and Gear As- sembly

Units using meda with a liner (PCC digit 8 = A or C): Insert one end of the Peeler Bar into the Inner Cover. Pivot the other end of the bar down and snap it into the Inner Cover.

AN16792-009- Installing the Scraper

Units using linerless meda (PCC digit 8 = B or D): :Snap the Scraper into the Media Cov- er. The pins on the Scraper fit into the mounting holes for the Peeler Bar. The Scaper is used with linerless media only.

Scraper

• 2-57 • RMAN-QLS-002 rev. A Repair Procedures