Zebra Technologies Q4DLU1B000000, Q3DLUBA000002 manual From # of connections CPU Connector #

cables are locked.

11.Assemble the Upper Housing to the Printer, and secure it with the retained hard- ware. At this time either the “D” rings, or the Carrying strap which was supplied with the printer should be reassembled. Note that the longer screws are used to secure the “D” rings.

6.Install the QuickLink module. Plug the either the QuickLink module or the mod- ule housing supplied with the printer into the Top Housing, and secure with (1) screw through the battery compartment.

7.Install the Battery Pack. Reinstall the Battery Pack and perform a two-key reset to verify that the Printer has been properly reassembled.

8.Perfom the Unit Test procedure. Perform a complete unit test to ensure that the sensor calibrations are still correct, and the motor is operating correctly.

4 3

	5
5	5
	5

J3

J4		J10
	J5	J11
		J2

From	# of connections	CPU Connector #
Printhead	28 (Flex)	J3
Motor	4	J4
Media Width Sensor (optional)	3	J11 (bottom of board)
Bar Sensor Cable	3 (Flex)	J2
Gap Sensor/Printhead Ground	5 (Flex)	J10
Label Presence Sensor	4 (Flex)	J5

• 2-85 • RMAN-QLS-002 rev. A Repair Procedures