Zebra Technologies Q4DLU1B000000 Motor,QL220 & QL 220 Plus AN16972-002, Installing the Motor

Motor,QL220 & QL 220 Plus - AN16972-002

You must use an ESD strap and work at a properly grounded workstation (antistatic mat or tray). All electronic components must be placed on an ESD protective tray. If stored, any elec- tronic components must be placed in antistatic bags.

Preparation

1.Remove the Upper and Lower Housings and the PCB Cover.

2.Remove the MLB from the printer.

3.Remove the Printer Frame.

Installing the Motor

1.Insert the pinion of the Motor into the Printer Frame, noting location of the wires and connector. When the Motor’s mounting flange is in contact with the

Printer Frame, rotate the Motor in the direction shown until it seats into place.

Note: Push the Rack Lock away from the Motor while assembling.

2.Secure the Motor with a Screw in the top hole of the Motor’s mounting flange.

Screw, Socket Hd. #4-40 x 3/16” Torque = 5 in/lbs.

Motor

Push Rack Lock against Printer Frame while in- stalling Motor

• 2-83 • RMAN-QLS-002 rev. A Repair Procedures