Cover.

6. Re-attach the MLB and display.

From

# of connections

CPU Connector #

 

 

 

Printhead

Flex circuit

J3

 

(28 conductor)

 

Motor Cable

4

J4

Media Width

3

J11 (bottom

Sensor (optional)

 

of board)

Bar Sensor Cable

Flex circuit

J2

 

(3 conductor)

 

Gap Sensro/

Flex circuit

J10

Printhead Ground

(5 conductor)

 

 

 

 

Label Presence Sensor

Flex Circuit

J5

 

(4 conductor)

 

Plug the cables from the printer back into the MLB per the following table:

7.Reassemble the Upper Cover and Module Housing

Re-install the Upper Housing per AN16861-010 (QL320) or AN16753-007 (QL 420).

When re-installing the Upper Housing for the QL 420, ensure that the proper Corner Attachment Kit (ref. AN16753-010) is also re-installed.

Install the Module Housing as shown below Ensure the Module is secured with the retained screw through the battery compartment.

8.Install the Battery and test the unit.

Install the Battery and turn the unit on.

Verify that all indicator lights turn on properly.

Verify proper operation of the printer by performing a two-key reset.

It is recommended you perform a complete unit test to verify proper opera- tion of all the printer features.

RMAN-QLS-002 rev. A Repair Procedures

2-80

Page 57
Image 57
Zebra Technologies Q3DLUBA000002, Q4DLU1B000000 manual From # of connections CPU Connector #