Zebra Technologies Q3DLUBA000002, Q4DLU1B000000 manual Removing the Peeler Shaft and Roller

Peeler Shaft & Roller, QL 220/220 Plus- AN16972-006; QL 320/ QL 320 Plus- AN16861-026 & QL 420- AN16753-024

You must use an ESD strap and work at a properly grounded workstation (antistatic mat or tray). All electronic components must be placed on an ESD protective tray. If stored, any elec- tronic components must be placed in antistatic bags.

Preparation:

1.Turn the printer off and remove the battery pack.

2.Remove the Latch Assembly Module

Removing the Peeler Shaft and Roller

1.Turn the Latch Assembly upside down.

2.Carefully pull on one flange of the plastic latch and pull out the Peeler Shaft and Roller Assembly. Ensure the two springs and journals installed in the Latch As- sembly remain in place.

Installing the Peeler Shaft and Roller

1.Snap the new Peeler Shaft and Roller Assembly into the Latch. The tabs on the bottom of the Peeler Bail will sit in the Journals. The guides on the side of the Peeler Shaft and Roller Assembly should ride in the guides on the Latch.

The Peeler Bail Assembly should pivot freely back and forth inside the Latch, and detent into the open and closed positions.

2.Install the Latch Assembly per AN16972-004 (QL 220); AN16861-025 (QL 320) or AN16753-011 (QL 420) and reassemble the printer.

Journal (part of Latch Assembly )

Note position of “ears”

Peeler Shaft and Roller Assembly

This feature will ride in the guide slots on the side of the Latch

Spring (part of

Latch Assembly)

Latch Assembly

RMAN-QLS-002 rev. A Repair Procedures • 2-98 •