Zebra Technologies Q4DLU1B000000, Q3DLUBA000002 manual Removing the D Rings, Installing the D Rings

Corner Attachment Kit, QL 320/320 Plus &

QL420/420 Plus- AN16753-010

Introduction:

This kit supplies you with the parts needed to:

•Replace the “D” rings supplied as standard equipment with the printer. or

•Install the bushings supplied for use with the optional carrying strap.

Tools needed:

3/32” hex driver

Removing the “D” Rings

1.Remove the (2) Screws securing the upper and lower covers of the printer.

2.Slide the (2) “D” rings out from the Printer.

Installing the “D” Rings

1.Slide the (2) “D” rings into the Printer.

2.Install the (2) Screws supplied with the kit.

Removing the Bushings

1.Remove the (2) Screws securing the upper and lower covers of the printer,

2.Slide the (2) bushings and the Carrying Strap out from the Printer.

Installing the Bushings

1.Slide the (2) bushings supplied with the kit into the loops of the Carrying Strap (not supplied with this kit.) If you will be installing a printer in a Mobile Mount application, you should not install the carrying strap.

2.Slide the Bushings back into the Printer between the upper and lower housings.

3.Install the (2) Screws supplied with the kit.

Carrying Strap

“D” Ring

Bushing

Screw

• 2-109 • RMAN-QLS-002 rev. A Repair Procedures