Black & Decker BSL100 Features, Use, Charging the spotlight, Using the built-in carry lanyard

Page 9

ENGLISH

Chargers

Your charger has been designed for a specific voltage. Always check that the mains voltage corresponds to the voltage on the rating plate.

Warning! Never attempt to replace the charger unit with a regular mains plug.

Use your Black & Decker charger only to charge the battery in the tool with which it was supplied. Other batteries could burst, causing personal injury and damage.

Have defective cords replaced immediately.

Do not expose the charger to water. Do not open the charger.

Do not probe the charger.

The spotlight must be placed in a well ventilated area when charging.

All batteries lose charge with time, specially when they are warm. Recharge the unit every two months for 24 hours when not in frequent use.

If the unit is not going to be used for extended periods, disconnect the charger and store in a cool, dry place.

The following symbols are found on your charger:

Your charger is double insulated; therefore no earth wire is required.

Read all of this instruction manual carefully.

This appliance is intended for indoor use only

130oC

The charger automatically shuts off if the ambient

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

temperature becomes too high. As a consequence

 

 

 

 

 

 

the charger will be inoperable. The charging base

 

 

 

 

 

 

must be disconnected from the mains supply and

 

 

 

 

 

 

taken to an authorised service centre for repair.

 

 

 

 

 

 

This product must not be disposed of with normal

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

household waste.

 

 

 

 

 

 

Electrical safety

 

 

 

 

 

 

Your charger is double insulated; therefore no earth

 

 

 

 

 

 

wire is required. Always check that the main voltage

 

 

 

 

 

 

corresponds to the voltage on the rating plate.

 

 

 

 

 

 

Warning! If the power cord is damaged, it must be

 

 

 

 

 

 

replaced by the manufacturer, authorized

 

 

 

 

 

 

Black & Decker Service Center or an equally qualified

 

 

 

 

 

 

person in order to avoid damage or injury. If the power

 

 

 

 

 

 

cord is replaced by an equally qualified person, but

 

 

 

 

 

 

not authorized by Black & Decker, the warranty will

 

 

 

 

 

 

not be valid.

FEATURES

This appliance includes some or all of the following features:

1.Rubber ring guard

2.Charge LED

3.Charging socket

4.Carry lanyard

5.Trigger switch

6.Charger jack plug

7.Mains charging adaptor

Charging the spotlight

This spotlight is shipped in a partially charged state.

Charge the spotlight before first use using the mains charging adaptor (7) for 18 hours.

Warning! Do not charge for longer than 48 hours.

Insert the charger jack plug (6) into the charging socket (3).

Insert the mains charging adaptor (7) into a mains power socket.

The red charge LED (2) will light when the unit is charging.

USE

Before operating the spotlight remove the charger jack plug (6) from the charging socket (3).

Using the built-in carry lanyard

The carry lanyard (4) may be used to store or carry the spotlight. Adjust the slide on the cords to keep the lanyard secure around the supporting object.

9

Image 9
Contents Manual DE Instrucciones USO Previsto EspañolInstrucciones DE Seguridad Instrucciones DE Seguridad Específicas Para ReflectoresUSO CaracterísticasProtección DEL Medio Ambiente MantenimientoInformación DE Servicio Especificaciones BSL100Utilização PortuguêsInstruções DE Segurança Instruções DE Segurança Específicas Para O Farol PortátilUtilização FunçõesProteção do Ambiente ManutençãoInformações DE Serviço Especificações CarregadorSpecific Safety Instructions For Spotlights Safety InstructionsEnglish Intended USEUsing the built-in carry lanyard FeaturesUSE Charging the spotlightService Information Specifications MaintenanceProtecting the Environment Charger