Menu Functions
Service Functions
To test the fixture:
1)Use the “Test” function under the “1.3 Operation” menu (see page 14).
To reset the fixture:
1)Use the “4.2 Reset” function under the
To restore all settings to their factory defaults:
1)Use the “6.1 Default” function under the
Operation
Master/Slave Mode (Master Sound, Master Auto):
This mode will allow you to link up to 32 units together without a controller.
1)Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of the units. For longer cable runs we suggest a terminator at the last fixture.
2)Choose a unit to function as the Master. Turn dipswitches to the Master position on the unit. The unit must be the first unit in line. Then simply chain the units together using DMX cable.
Note: The master unit must be in one of the Auto or Sound modes. See the Menu Map for setting the options in the menu and navigating the Control Board.
3)Adjust the “Operation” to “Slave” on the slave units, and they will react the same as the Master unit. Note: if you would like to have the fixtures invert, then you can set this in the Control board.
DMX Mode
This mode allows the unit to be controlled by any universal DMX controller. If you are unfamiliar with DMX, please read the DMX Primer section.
1)Set the “Operation” to “DMX512”.
2)Set your DMX starting address.
DMX Channel Values
The
15 | 9/22/2009 3:57 PM |