Chauvet QSPOT user manual Spot 150-LED Troubleshooting, Technical Support

Page 20

Q-Spot™ 150-LED Troubleshooting

Symptom

Solution(s)

 

 

Beam is very dim or not

Clean optical SYSTEM

bright

 

Breaker/Fuse keeps

Check total load placed on device

blowing

 

Device has no power

Check for power on Mains.

 

Check device’s fuse. (internal and/or external)

Fixture is not responding

Check DMX Dip switch settings for correct

 

addressing

 

Check DMX cables

 

Check polarity switch settings

Fixture is on but there is

Make sure you have the correct audio mode on the

no movement to the audio

control switches.

Loss of signal

Use only DMX cables

 

Install terminator

 

Note: Keep DMX cables separated from power

 

cables or black lights.

Moves slow

Check 220/110v switch for proper setting

 

 

No light output

Call service technician

 

 

Stand alone mode

This fixture contains standalone programs. Please

 

see the appropriate section(s) for the details of

 

operation

 

 

If you still have a problem after trying the above solutions, please contact CHAUVET Technical Support at the location on the next page.

Technical Support

Address: Service Dept.

3000 N 29th Ct, Hollywood, FL 33020 (U.S.A.) Support (Email): tech@chauvetlighting.com Telephone: (954) 929-1115 - (Press 4)

Fax: (954) 929-5560 - (Attention: Service)

Website: http://www.chauvetlighting.com

Q-Spot™ 150-LED User Manual

20

9/22/2009 3:57 PM

Image 20
Contents Snapshot Table of Contents What is included AC PowerBefore YOU Begin Unpacking InstructionsSafety Instructions Replace with same partsDMX Channel Summary FeaturesIntroduction Product Overview Product Dimensions Replacing Gobos SetupFuse Replacement Gobo and Color Wheel Diagrams Cable Connectors Fixture LinkingData Cabling DMX Data CablePin to 5-Pin Conversion Chart Setting up a DMX Serial DataLink Master/Slave Fixture LinkingMounting Orientation RiggingOperating Instructions Navigating the Control PanelMenu Map IntroMenu Functions Service Functions To test the fixture To reset the fixtureTo restore all settings to their factory defaults Operation Master/Slave Mode Master Sound, Master AutoAdvanced 16-bit Basic 8-bit DMX Primer Setting the DMX Starting AddressAppendix Claims General MaintenanceReturns Procedure Spot 150-LED Troubleshooting Technical SupportExploded View Photometrics Technical Specifications Power