Chauvet QSPOT Before YOU Begin, What is included, Unpacking Instructions, AC Power, Contact Us

Page 3

1.BEFORE YOU BEGIN

What is included

1 x Q-Spot™ 150-LED

1 x Set of 3 extra gobos

1 x Bracket set

1 x Power Cord

1 x Warranty Card

1 x User Manual

Unpacking Instructions

Immediately upon receiving a fixture, carefully unpack the carton, check the contents to ensure that all parts are present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if any parts appear damaged from shipping or the carton itself shows signs of mishandling. Save the carton and all packing materials. In the event that a fixture must be returned to the factory, it is important that the fixture be returned in the original factory box and packing.

AC Power

This fixture has an auto-switching power supply that can accommodate a wide range of input voltages. The only thing necessary to do before powering on the unit is to make sure the line voltage you are applying is within the range of accepted voltages. This fixture will accommodate between 100 V and 240 VAC, 50/60 Hz. All fixtures must be powered directly off a switched circuit and cannot be run off a rheostat (variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used solely for a 0% to 100% switch.

Warning! All fixtures must be connected to circuits with a suitable Earth Ground.

Contact Us

World W ide

General Information

CHAUVET

 

3000 North 29th Court

 

Hollywood, FL 33020

 

voice:

954.929.1115

 

fax:

954.929.5560

 

toll free: 800.762.1084

Technical Support

CHAUVET

 

3000 North 29th Court

 

Hollywood, FL 33020

 

voice:

954.929.1115 (Press 4)

 

fax:

954.929.5560 (Attention: Service)

World Wide Web

www.chauvetlighting.com

Q-Spot™ 150-LED User Manual

3

9/22/2009 3:57 PM

Image 3
Contents Snapshot Table of Contents Unpacking Instructions What is includedAC Power Before YOU BeginReplace with same parts Safety InstructionsFeatures IntroductionDMX Channel Summary Product Overview Product Dimensions Setup Fuse ReplacementReplacing Gobos Gobo and Color Wheel Diagrams DMX Data Cable Cable ConnectorsFixture Linking Data CablingMaster/Slave Fixture Linking Pin to 5-Pin Conversion ChartSetting up a DMX Serial Data LinkRigging Mounting OrientationNavigating the Control Panel Operating InstructionsIntro Menu MapOperation Master/Slave Mode Master Sound, Master Auto Menu Functions Service Functions To test the fixtureTo reset the fixture To restore all settings to their factory defaultsAdvanced 16-bit Basic 8-bit Setting the DMX Starting Address AppendixDMX Primer General Maintenance Returns ProcedureClaims Technical Support Spot 150-LED TroubleshootingExploded View Power Photometrics Technical Specifications