RULES FOR SAFE OPERATION (Continued)
SAFETY RULES FOR WORKLIGHTS
,_ WARNING: Do not operate worklight or charger near flammable liquids or in gaseous or
explosive atmospheres. Internal sparks may ignite fumes.
,_1 WARNING: Lens and bulb become hot during
use
•During or immediately after use, don'tlay worklight flat on lens surface or place lens
area in contact with a plastic or fabric covered surface.
•Handle worklight with care around any flammable surface.
•Let worklight cool for several minutes after use before changing bulb.
•Do not use or permit use of worklight in bed or sleeping bags. This worklight lens can melt fabric and a burn injury could result.
IMPORTANT SAFETY RULES FOR BATTERY TOOLS
•USE ONLY THE CHARGER RECOMMENDED FOR USE WITH YOUR WORKLIGHT. Do not substitute any other charger. Use of another charger could cause batteries to explode causing possible serious injury.
•Your battery tool should be charged in a location where the temperature is more than 50°F but less than 100°F.
Under extreme usage or temperature conditions, battery leakage may occur. If liquid comes in contact with your skin, wash immediately with soap and water, then neutralize with lemon juice or vinegar. If liquid gets in your eyes, flush them with clean water for at least 10 minutes, then seek immediate medical attention.
WARNING: Batteries vent hydrogen gas and can explode in the presence of a source of ignition, such as a pilot light. To reduce the risk of serious personal injury, never use any cordless product in the presence of open flame. An exploded battery can propel debris and chemicals. If exposed, flush with water immedi- ately.
_, WARNING: Never use a battery pack that has been damaged or received a sharp blow. A
damaged battery pack is subject to explosion. Properly dispose of a damaged battery pack immediately. Failure to heed this warning can result in serious personal injury.
WHEN SERVICING USE ONLY IDENTICAL
CRAFTSMAN REPLACEMENT PARTS.
IMPORTANT SAFETY INSTRUCTIONS FOR CHARGER
Before using battery charger, read all instructions and cautionary markings in this manual, on battery charger, and product using battery charger.
,a,CAUTION: To reduce the risk of injury, charge only
•Do not expose to wet or damp conditions.
•To reduce the risk of damage to charger body and cord, pull by charger plug rather than cord when disconnecting charger.
•An extension cord should not be used unless
absolutely necessary. Use of improper extension cord could result in a risk of fire and electric
shock. If extension cord must be used, make sure:
a. That pins on plug of extension cord are the same number, size and shape as those of plug on charger.
b.That extension cord is properly wired and in good electrical condition; and
c.That wire size is large enough for AC ampere rating of charger as specified below:
Cord Length (Feet) 25' 50' 100'
Cord Size(AWG) 16 16 16
Note: AWG = American Wire Gage
DO NOT OPERATE CHARGER WITH A DAMAGED CORD OR PLUG. If damaged, have replaced immediately by a qualified serviceman.
Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged in any way; take it to a qualified serviceman.
Do not disassemble charger; take it to a qualified serviceman when service or repair is required. Incorrect reassembly may result in a risk of electric shock or fire.
To reduce the risk of electric shock, unplug charger from outlet before attempting any maintenance or cleaning. Turning off controls will not reduce this risk.
•Do not use charger in wet or damp conditions.
•Disconnect charger from power supply when not in
use.
•SAVE THESE INSTRUCTIONS. Review them frequently and use them to instruct others who may use this light. If you loan someone this light, loan them these instructions also.
SAVE THESE INSTRUCTIONS