Harbor Freight Tools 95578 operating instructions Operating Instructions, Figure E

Page 11

install the convex (rounded outward) side of the Grinding Wheel toward the Spindle (7). (See Figure E.)

3.Screw the Outer Flange Nut (1) onto the Spindle (7). Depress and hold the Lock Pin (22) to keep the Spindle from turning. Then, use the provided Wrench (51) to firmly tighten the Outer Flange Nut onto the Spindle. (See Figure E.)

A

GRINDING

WHEEL

SPINDLE

(7)

OUTER

FLANGE

NUT

(1)

B

OUTER

FLANGE

NUT

(1)

C

LOCK PIN

(22)

WRENCH

(51)

FIGURE E

To Attach The Side Handle:

1.The Side Handle (18) may be attached to either the left or right side of the Angle Grinder. (See Figure F.)

2.To attach the Side Handle (18) to the Angle Grinder, screw the Handle firmly into the threaded mounting hole located on either the left or right side of the Shell Head (23). (See Figure F.)

SHELL

HEAD

SIDE

(23)

FIGURE F

HANDLE

(18)

OPERATING INSTRUCTIONS

1. WARNING! Make sure the Power Switch (41) of the Angle Grinder is in its “OFF” position before connecting the Power Cord/Plug (50) to a 120 volt, grounded, electrical outlet.

SKU 95578 For technical questions, please call 1-800-444-3353 PAGE 11

Image 11

Contents 2 Angle Grinder Work Area Product SpecificationsGeneral Safety Rules Save this ManualPersonal Safety Electrical SafetyTool USE and Care Service Specific Safety RulesPage Grounded Tools Tools with Three Prong Plugs GroundingThis Product Uses a Prong Plug This Product Does not USE a Prong PlugDouble Insulated Tools Tools with TWO Prong Plugs Extension Cords Recommended Minimum Wire Gauge for Extension CordsUnpacking SymbologyAssembly Instructions Figure E Operating InstructionsFigure G INSPECTION, MAINTENANCE, and CleaningProblem Possible Solution TroubleshootingDescription Parts List and Assembly DiagramImportant Warranty Information Limited 90 DAY Warranty