Harbor Freight Tools 95578 Recommended Minimum Wire Gauge for Extension Cords

Page 9

EXTENSION CORDS

1.Grounded tools require a three wire extension cord. Double Insulated tools can use either a two or three wire extension cord.

2.As the distance from the supply outlet increases, you must use a heavier gauge extension cord. Using extension cords with inadequately sized wire causes a serious drop in voltage, resulting in loss of power and possible tool damage.

(See Figures C.)

3.The smaller the gauge number of the wire, the greater the capacity of the cord. For example, a 14 gauge cord can carry a higher current than a 16 gauge cord.

(See Figures C.)

4.When using more than one extension cord to make up the total length, make sure each cord contains at least the minimum wire size required.

(See Figures C.)

5.If you are using one extension cord for more than one tool, add the nameplate amperes and use the sum to determine the required minimum cord size.

(See Figures C.)

6.If you are using an extension cord outdoors, make sure it is marked with the suffix “W-A” (“W” in Canada) to indicate it is acceptable for outdoor use.

7.Make sure your extension cord is properly wired and in good electrical condition. Always replace a damaged extension cord or have it repaired by a qualified electrician before using it.

8.Protect your extension cords from sharp objects, excessive heat, and damp or

RECOMMENDED MINIMUM WIRE GAUGE FOR EXTENSION CORDS*

wet areas.

(120 VOLT)

 

FIGURE C

*Based on limiting the line voltage drop to five volts at 150% of the rated amperes.

SKU 95578 For technical questions, please call 1-800-444-3353 PAGE 9

Image 9
Contents 2 Angle Grinder General Safety Rules Product SpecificationsSave this Manual Work AreaPersonal Safety Electrical SafetyTool USE and Care Service Specific Safety RulesPage Grounded Tools Tools with Three Prong Plugs GroundingThis Product Does not USE a Prong Plug Double Insulated Tools Tools with TWO Prong PlugsThis Product Uses a Prong Plug Extension Cords Recommended Minimum Wire Gauge for Extension CordsSymbology Assembly InstructionsUnpacking Figure E Operating InstructionsFigure G INSPECTION, MAINTENANCE, and CleaningProblem Possible Solution TroubleshootingDescription Parts List and Assembly DiagramImportant Warranty Information Limited 90 DAY Warranty