Step 6: To operate the Angle Grinder, press the THROTTLE LEVER LOCK (#61) forward while depressing the THROTTLE LEVER (#59) as shown in Figure 6.
Throttle Lever (#59)
Throttle Lever Lock (#61)
Figure 6 — Operating the Angle Grinder
Step 7: Place the spinning GRINDING WHEEL (#45) onto the material to be ground. Let the weight of the Angle Grinder do the work. Do not press the Angle Grinder into the material. If the Angle Grinder stalls, release the THROTTLE LEVER immediately.
Step 8: Grind using the outside diameter of the GRINDING WHEEL as much as possible. Do not attempt to use the recessed inner diameter of the GRINDING wheel as you may damage the FLANGE NUT (#46).
MAINTENANCE
Your Angle Grinder is best operated with an Airline Oiler. If you are using the Angle Grinder without an Airline Oiler, follow the steps below for maintenance.
Step 1: Disconnect the Angle Grinder from the air hose.
Step 2: Apply a few drops of PNEUMATIC TOOL OIL through the air line before each use, or every hour if used continuously.
CAUTION
Do not use detergent oil or additives as these lubricants will cause accelerated wear to the seals in the tool.