Grizzly H7507 owner manual Assembly, To assemble and install your router table extension wing

Page 13

Assembly

The Model H7507 mounts on most table saws that have 27" deep tables. If your table saw does not have mounting holes that match the router table, you will need to drill and tap the holes yourself.

Also, you may have to modify the fence rails for mounting the router table. Read this entire assem- bly section before you begin the installation pro- cedure below to make sure the H7507 will fit your table saw before making any modifications.

To assemble and install your router table extension wing:

1.DISCONNECT TABLE SAW FROM POWER!

2.Remove the right extension wing of the saw table and use the mounting holes shown in Figure 4 to install the router table in its place.

BV^cIVWaZ

GdjiZgIVWaZ

 

Bdjci^c\

 

=daZh

Figure 4. Mounting holes in router table and saw

table.

Note: There are other ways to attach the router table to a table saw, but these may require modifications to the saw.

3.With the help of another person to hold the router table, align the mounting holes in both tables and secure them together with the (3) 38"-16 x 114" bolts, (3) 38" lock washers, and

(3)38" flat washers, as shown in Figure 5. Finger tighten.

GdjiZgIVWaZ

(¿-"&+m&&¿)

=Zm7dai

BV^cIVWaZ

(¿-

AdX`

LVh]Zg

(¿-;aViLVh]Zg

Figure 5. Example of mounting route table to

table saw.

4.Place the straightedge across the saw table and router table to make sure that the com- bined table surface is flat.

—If the combined table surface is flat, con- tinue with Step 5.

—If the outside edge of the router table tilts down, place strips of masking tape along the bottom edge of the saw table to shim the router table up and even with the saw table from side to side (see Figure 6).

IVeZ

Figure 6. Using tape to shim the router table up.

Model H7507 (Mfg. since 3/05)

-11-

Image 13
Contents Model H7507 Router Table Extension Ss ,EAD from Leadbased PAINTS Table of Contents Manual Accuracy Machine Description IntroductionContact Info Identification Safety Instructions for Machinery SafetyModel H7507 Mfg. since 3/05 Additional Safety for Router Tables Needed for Setup SetupUnpacking Description QtyInventory Box Contents Figures 1 QtyHardware and Tools Not Shown Router Table GuardHardware Recognition Chart Before cleaning, gather the following ™ 9hedhVWaZGV\h CleanupTo assemble and install your router table extension wing AssemblyExcess masking tape with a razor blade To mount a router to the router table Mounting RouterRouter Guard To make a shop made fence and install the router guardStep Make a 28 long fence that is 23⁄4 tall ¿ - Recommended CFM at Dust Port 225 CFM Dust CollectionOperation Overview OperationsTable Inserts Workpiece InspectionEdge Jointing To joint the edge of a workpieceEdge jointing guard removed for Clarity Routing Small Stock Groove CuttingTo cut a groove into the face of the workpiece To make a zero-clearance fenceFree-Hand Routing GdjiZg IVWaZ Cleaning MaintenanceSchedule Unpainted Cast IronMain Parts10. 8dbbZcih Warranty Card99.$5342!, .# 0//88 %,,.!- 7!  Warranty and Returns Order Hours a DAY