6.Slide (2)
Fence Support
Mounting
Star Knobs
Figure 6. Fence support attached to the table
top.
7.Peel the adhesive from the scale tapes, then apply them to the tops of the fence boards.
Note: When installing the fence boards in the next step, make sure the 0" ends of the tapes are nearest the center of the table.
8.Slide the heads of (4) M8-1.25 x 25 hex bolts into the fence board T-slots, insert the bolts through the holes in the fence support, then secure the fence boards with (4) 8mm flat washers and M8-1.25 star knobs, as shown in Figure 7.
Fence Board
(1 of 2)
Scale
Tape
Fence Board
Star Knob
Figure 7. Fence boards secured to the fence
support.
9.Slide the heads of the (2) M6-1 x 25 T-bolts into the T-slots on the fence board faces, position them towards the center, slide the router guard over the bolts, then secure it in place with the (2) 6mm flat washers and M6-1 tri-knobs, as shown in Figure 8.
Router Guard
Figure 8. Router guard installed.
10.Slide the dust port onto the dust port housing, then attach the assembly to rear of the fence support with the (2) M5-.8 x 55 Phillips head screws, as shown in Figure 9.
x 2
Figure 9. Dust port assembly attached to the
fence support.
DO NOT operate the attached router without an adequate dust collection system. Follow your router manufacturer's specifications for the required dust collection capacity. Failure to use a dust collection system can result in short and
Model T10432 (Mfg. Since 11/10)