Grizzly T10432 owner manual Assembly, To assemble the router table

Page 11

Assembly

To assemble the router table:

1.Turn the table upside down on a protective surface, then attach the (2) long top stand braces to the table with (4) M6-1 x 18 hex bolts and 6mm fender washers, as shown in

Figure 2.

x 4

Long Top

Stand Braces

Figure 2. Long top stand braces attached to the

underside of the table.

2.Attach each stand leg to a long and short top brace with (16) M8-1.25 x 10 carriage bolts, 8mm flat washers, and M8-1.25 hex nuts, as shown in Figure 3.

Note: For now, hand-tighten the stand fasten- ers. In a later step, the stand will be squared up and the fasteners fully tightened.

Short Top

Stand Brace

Leg

x 16

Figure 3. Stand legs and short top stand braces

attached.

Model T10432 (Mfg. Since 11/10)

3.Attach the long bottom stand braces to the legs with (8) M8-1.25 x 10 carriage bolts, 8mm flat washers, and M8-1.25 hex nuts, as shown in Figure 4.

Long Bottom

Stand Brace

x 8

Figure 4. Long bottom stand braces attached.

4.Attach the short bottom stand braces with the remaining (8) M8-1.25 x 10 carriage bolts, 8mm flat washers, and M8-1.25 hex nuts, as shown in Figure 5.

Short Bottom

Stand Braces

x 8

Figure 5. Short bottom stand braces attached to

the legs.

5.Install the (4) rubber feet onto the ends of the legs. Turn the stand and table assembly over, square up the stand, then fully tighten all the fasteners.

-9-

Image 11
Contents Model T10432 Router Table w/STAND Page Important Notice Table of ContentsRouter table Description IntroductionManual Accuracy Contact Info Machine Data Sheet Safety Instructions for Machinery SafetyUnattended OPERATION. Never­ leave­ Additional Safety for Router Tables Description Qty SetupNeeded for Setup UnpackingInventory Figure Qty InventoryTo assemble the router table AssemblyDust port assembly attached to Fence support To install your router onto the mounting board Router InstallationTools Needed Qty Aligning Router Mounting BoardOperation Overview OperationsSquaring Fence Workpiece InspectionTo joint the edge of a workpiece Edge JointingTo make a zero-clearance fence Profile RoutingRouting Small Stock To cut a profile into the workpieceFree-Hand Routing Workpiece Daily Check MaintenanceCleaning Protecting ScheduleStand & Fence Parts PartsTable Parts & Labels Model T10432 Mfg. Since 11/10 Comments Warranty CardBOX BELLINGHAM, WA Grizzly INDUSTRIAL, INCWarranty and Returns Warranty and ReturnsOrder Hours a DAY