PowerVault 130T Drive
Installation Instructions
DLT Drive Tray Assembly
These installation instructions describes how to remove, install and configure a DLT Drive Tray Assembly into the PowerVault 130T.
Before beginning this procedure be sure to take note of your drive configuration. You may need this later to reconfigure your new or additional drives.
NOTE: Tape drives are hot swappable, meaning they can be removed and replaced without powering off the library or interrupting its operations. Hot swapping should only be performed by trained technicians.
WARNING: HIGH VOLTAGE! DO NOT TOUCH any components on the power supply located within the electronics module or on the drive trays. Live voltage could be present even though the unit is powered off. (Refer to U03 in Safety Booklet)
Removing the DLT Drive Tray Assembly
CAUTION: If the drives are
Follow the instructions below to remove a DLT Drive Tray Assembly. The tape drives are located in the tape drive slots at the left rear of the library.
1.Loosen the three thumbscrews from the hinged door at the rear of the library and open the door.
Drive Tray Conversion Instructions | 1 |