Scroll using the arrow buttons to select the correct drive (drives are numbered 0 through 3 starting from the bottom).
A
The factory drive settings are below:
Drive 0 | SCSI ID 1 |
Drive 1 | SCSI ID 2 |
8.When finished with all the above settings, press MENU. If you have set or changed the Drive Count the following message appears on the display:
New configuration requires mach reset. Push SYSTEM RESET
Push SYSTEM RESET at this time. The library
ENTER Unlocks CAP
If not required to reset, press MENU until the above message appears on the operator panel.
The library is now ready to use. Refer to the PowerVault 130T User’s Guide for instructions on operating the library.
8 Drive Tray Assembly Conversion Instructions